Air mattress vent method:
1) Open the air nozzle, roll up from the other end of the air nozzle, pressure out air.
2) Close the air nozzle, roll up the air cushion bed by the other end, and open the air nozzle again to discharge the residual air.
3) Finally close the valve, at any time can be rolled state preservation. Note: Please put it in the outsourcing bag to avoid scratching.
When deflating, pull open the gas valve, the gas will naturally be discharged from the bed. There are two methods: first, the general use of air bed, will spread a sheet on the bed, put a bamboo "mahjong" mat in summer, spread a thick quilt or cotton wool in winter, so that it can achieve the effect of warm in winter and cool in summer. When deflating, dial open gas valve, gas will naturally discharge from the bed, plus the bed has mat or quilt pressure, exhaust speed is very fast, less than a minute, will naturally discharge clean, pressure more heavy discharge faster. It's the fastest way to vent the gas. Two, if there is no mat or quilt on the bed, then when deflating, dial open the gas valve to let its natural discharge clean, before and after only four minutes, at this time if the hand pressure, the discharge will be accelerated.
Open the nozzle, roll up from the other end of the nozzle, press out air and tighten the nozzle. You can repeat the above steps and try to make the air mattress completely deflated to obtain a smaller collection volume. Storage method: 1) Spread the air mattress flat, open the air nozzle, inflate the air cushion, and store it in a cool place. 2) When not used for a long time, please be sure to keep the air cushion in the inflatable state to ensure that the elasticity of the foam is not damaged. Cleaning method: After aeration, tighten the air nozzle, scrub with a soft brush in neutral cleaning solution, rinse with clean water, and store after natural drying. Repair methods: 1) wipe the repair area clean 2) Paste the patch actively on the hole 3) Do not inflate within 30 minutes after adhesion.